QR Code tile and display installation
You will need a shovel, tape measure, one cubic foot of river pebbles, or similar-sized marble chips or crushed stone.
Your display is mounted on a sturdy post – 32″ long – eighteen inches are to be buried. 
You will be given two 6-inch aluminum rods; insert them in the openings near the bottom of the post, as shown here. Together with the pebbles or stones, they secure the display in place.
Open an 8–12-inch diameter hole twenty inches deep. Then fill the hole with 2 inches of the stone and lower the display (with the rods installed). Being cautious of the display’s orientation, fill the gap with more stone to within 4 inches of the surface.
Your customized ceramic tile is adhered to the display using E6800 adhesive. You will need to pick up a tube and follow its directions.
E6800 UV Industrial Adhesive Clear is a medium viscosity, perchloroethylene adhesive used for marine and outdoor applications.
- Temperature resistant – unaffected by extreme heat or cold once cured
Your handsome display, along with your customized QR Code tile, securely installed, and complimentary stick USA flag
Complete re-filling of the hole using the ground material removed earlier.
